Ok guys, I'm a complete noob when it comes to RZRs. My last UTV was a 2012 Ranger 500, it took me about 10 tries but I finally found a good setup on it for the areas we ride (woods and rocky creek beds). On the Ranger I ended up removing the sway bar, adding coil springs from an electric Ranger, a 2" SATV lift on the rear and my own 1.25" lift on the front. That gave me almost 13" of GC on 26" Bighorns and did a decent job of controlling body roll but still left a pretty plush ride.
On the RZR, all I have done is verify that everything is set per the stock settings in the manual. The front feels pretty good (maybe a touch stiff), but the rear is really bouncy compared to my Ranger (assuming the sway bar is the reason).
Any suggestions on where to start? As soon as the Ranger sells, I plan to order a better set of springs but I'm stuck with the stock stuff until then.
On the RZR, all I have done is verify that everything is set per the stock settings in the manual. The front feels pretty good (maybe a touch stiff), but the rear is really bouncy compared to my Ranger (assuming the sway bar is the reason).
Any suggestions on where to start? As soon as the Ranger sells, I plan to order a better set of springs but I'm stuck with the stock stuff until then.