My rear bearings had some play, so I'm changing them out. The passenger side was easy, but the driver's side is frozen.
You can normally just slide the hub off once you remove the brake caliper, but it won't budge. I tried a gear puller, but it has three arms and just slips since the hub is shaped odd. I removed the whole assembly from the control arms, but I can't figure out a way to get it on my press. I put some pressure on it thinking if there was some play, it might squeeze the hub and spindle together enough to break it loose, but it didn't work.
Anyone else have this happen? Any ideas?
You can normally just slide the hub off once you remove the brake caliper, but it won't budge. I tried a gear puller, but it has three arms and just slips since the hub is shaped odd. I removed the whole assembly from the control arms, but I can't figure out a way to get it on my press. I put some pressure on it thinking if there was some play, it might squeeze the hub and spindle together enough to break it loose, but it didn't work.
Anyone else have this happen? Any ideas?